Audi A6 Typ 4G: Valet Parking function
Applies to: vehicles with Valet Parking function
The valet parking function protects the luggage
comportment from unauthorized access.
Fig. 34 Glove compartment: valet parking fun ct ion button
You can switch the valet parking function on, for
example when someone else is parking your vehicle. When the function is switched
on, the vehicle
can be driven, locked and unlocked using
the master key, but access to the luggage compartment
is not permitted.
- Remove the integrated mechanical key.
- Open the glove compartment.
- Press the [VALET] button to switch the valet
parking function on. The LED in the button
turns on.
- Lock the glove compartment with the mechanical
key.
- Applies to vehicles with lockable backrests in
the rear: to also secure the luggage compartment
from the vehicle interior, lock the backrests
using the mechanical key.
- Only give the remote control key to the service
personnel parking your car and keep the removed
mechanical key with you.
The following buttons are deactivated when the
valet parking function is switched on:
- button in the driver's
door
- button on the remote
control key
- Handle in the rear lid
When the valet parking function is switched on,
the message Valet parking activated appears in the instrument cluster display
when you switch
the ignition on.
Tips
Please note that the luggage compartment
can still be accessed from the vehicle interior
in vehicles with a pass-through, even when
the valet parking function is switched on.
READ NEXT:
Description
Applies to: vehicles with garage door opener (HomeLink)
Fig. 35 Garage door opener: examples of usage for different
systems
With the garage door opener (HomeLink), you
can activate system
Switching lights on and off
Fig. 37 Instrument panel: light switch with all weather
lights
Light switch
Turn the switch to the corresponding position.
When the lights are switched on, the symbol
tu
SEE MORE:
General Information
Before beginning balancing, the following requirements must
be fulfilled.
Tire inflation pressure must be OK.
The tire tread must not be worn down on one side and should
be at least 4 mm deep.
The tire must not have any flat spots.
It is not possible to balance a flat spot
General Information
Perform a road test to determine if a vehicle pulls to one
side and if so, when and to which side. If the vehicle pulls to
one side, see procedure
→ Chapter "Corrective Action when Vehicle Pulls to One Side".
If the vehicle alignment is measured, submit the measurement