Audi A6 Typ 4G: Convertible child safety seats
Properly used convertible child safety seats can
help protect toddlers and children over age one
who weigh between 20 and 40 lbs. (9 and 18 kg)
in a crash.
Fig. 165 Schematic overview: installation of the attachments
applicable to a LATCH seat
Fig. 166 Schematic overview: installation of the seat using
the vehicle's safety belt system
- When using the vehicle safety belt to install a
child safety seat, you must first activate the
convertible locking retractor on the safety belt
to prevent the child safety seat from moving
or install the seat using the LATCH
attachments.
- Push the child safety seat down with your full
weight to get the safety belt really tight so that
the seat cannot move forward or sideways
more than one inch (2.5 cm).
- If the child safety seat is equipped with a tether
strap, attach it to the tether anchors.
- Secure unused safety belts on the rear seat
A toddler or child is usually too large for an infant
restraint if it is more than one year old and
weighs more than 20 lbs. (9 kg).
Toddlers and children who are older than one
year up to about 4 years old and weigh more than
20 lbs (9 kg) up to 40 lbs. (18 kg) must always be
properly restrained in a child safety seat certified
for their size and weight
fig. 165 and
fig. 166.
The airbag on the passenger side makes the front
seat a potentially dangerous place for a child to
ride. The front seat is not the safest place for a
child in a forward-facing child safety seat. It is a
very dangerous place for an infant or a larger
child in a rearward-facing seat.
WARNING
Not using a child safety seat, using the wrong
child safety seat or improperly installing a
child restraint increases the risk of serious
personal injury and death in a collision or other
emergency situation.
WARNING
If exceptional circumstances require the use
of a forward-facing child restraint on the
front passenger's seat, the child's safety and
well-being require that the following special
precautions be taken:
- Make sure the forward-facing seat has been
designed and certified by its manufacturer
for use on a front seat with a passenger
front and side airbag.
- Always follow the manufacturer's instructions
provided with the child safety seat or
infant carrier.
- Always move the front passenger seat to
the highest position in the up and down adjustment
range and move it back to the
rearmost position in the seat's fore and aft
adjustment range, as far away from the airbag
as possible, before installing the forward-
facing child restraint.
- Always make sure that the safety belt upper
anchorage is behind the child restraint and
not next to or in front of the child restraint
so that the safety belt will be properly positioned.
- Always make sure that nothing prevents the
front passenger's seat from being moved to
the rearmost position in its fore and aft adjustment
range.
- Always make sure the backrest is in an upright
position.
- Never place or use any electrical device
(such as a laptop, CD player, electronic
games device, power inverter or seat heater
for child seats) on the front passenger seat
if the device is connected to the 12-volt
socket.
- If a seat heater has been retrofitted or otherwise
added to the front passenger seat,
never install any child restraint system on
this seat.
- Make sure that there are no wet objects
(such as a wet towel) and no water or other
liquids on the front passenger seat cushion.
- Never place objects on the seat (such as a
laptop, CD player, electronic games device,
power inverter or seat heater for child
seats). These may influence the electrical
capacitance measured by the capacitive passenger
detection system and can also fly
around in an accident and cause serious personal
injury.
- Make sure that the PASSENGER AIR BAG
OFF light comes on and stays on all the time
whenever the ignition is switched on.
- If the PASSENGER AIR BAG OFF light does
not come on and stay on, immediately install
the forward-facing child seat at a seating
position on the rear seat and have the
airbag system inspected by your authorized
Audi dealer.
- Take the child restraint off the front passenger
seat and install it properly at one of the
rear seat positions if the PASSENGER AIR
BAG OFF light does not stay on whenever
the ignition is switched on.
READ NEXT:
Properly used booster seats con help protect
children weighing between about 40 lbs. and 80
lbs. (18 kg and 36 kg) who are less than 4 ft. 9
in. (57 inches/1.45 meters) tall.
Fig. 167 Rear seat: chil
Securing a child safety seat using a safety
belt
Safety belts for the rear seats and the front passenger
can be locked with the convertible locking
retractor to properly secure child safety seats.
The
Use the convertible locking retractor to secure a
child restraint.
Always heed the child safety seat manufacturer's
instructions when installing a child restraint in
your vehicle. To activate the conv
SEE MORE:
Vehicles with a High Voltage System (Hybrid Vehicles)
Extremely Dangerous Due to High-Voltage
The high-voltage system is under high-voltage. Death or serious
bodily injury by electric shock.
- Individuals with electronic/medical life- and health sustaining
machines in or on their person canno
Brake Pad Wear Indicator Wire, Removing and Installing, Steel Brakes,
1LA/1LJ
Removing
- Remove the affected front wheel. Refer to
→ Suspension, Wheels, Steering; Rep. Gr.44; Wheels, Tires.
- Disconnect the connector -2-
from the brake pad wear indicator.
- Release