Audi A6 Typ 4G: Electromechanical steering, dynamic
steering
The electromechanical steering supports the
driver's steering movements.
Power steering adapts electronically based on
the vehicle speed.
Indicator lights and messages
Do not drive vehicle:
steering defective
If this indicator light turns on and stays on and
this message appears, the power steering may
have failed.
Stop the vehicle in a safe location as soon as possible.
Do not continue driving. See an authorized
Audi dealer or authorized Audi Service Facility for
assistance.
Steering: System fault You
can continue
driving
If the indicator light turns on and the message
appears, the steering wheel may be more difficult
to move or more sensitive than usual. The
steering wheel may also be at an angle when
driving straight.
Drive slowly to an authorized Audi dealer or authorized
Audi Service Facility to have the malfunction
corrected.
Dynamic steering:
Initializing
If the indicator light is blinking and this message
appears, dynamic steering is being initialized.
The steering wheel will be easy to move after
starting the engine. Re-initialization might be
necessary if the steering wheel was moved hard
to the left and right while the vehicle was not
moving. The display turns off if the initialization
was successful.
Tips
- If the or
indicator light only stays on
for a short time, you may continue driving.
- The dynamic steering stability systems
are not available in the event of
a system malfunction.
- For additional information on dynamic
steering.
READ NEXT:
Applies to: vehicles with all wheel drive
In all wheel drive, all four wheels are powered.
General information
In all wheel drive, the driving power is divided between
all four wheels. This happens au
The starting ability is optimized
The energy management system manages the
electrical energy distribution and optimizes the
availability of electrical energy for starting the
engine.
When a vehicle wi
Event Data Recorder
This vehicle is equipped with an Event Data Recorder
(EDR). The main purpose of an EDR is to
record, in certain crash or near crash-like situations,
such as an airbag deployment or
SEE MORE:
Wire Routing and Securing
When loosing or removing and installing hydraulic, pneumatic or electrical
lines, draw sketches or take pictures. This will ensure they are installed in
their original positions.
Contact Corrosion
Contact corrosion can occur if incorrect fasteners (bolts,
nuts, washers,
Left/Right Rear Mid-Bass Speaker -R159-/-R160-, Removing and Installing
The Left Rear Mid-Bass Speaker -R159-/Right Rear Mid-Bass
Speaker -R160--2- are located at
the bottom of the rear doors.
Removing and installing is identical.
Removing
- Turn off the ignition and all electrical consumers