Audi A6 Owners & Service Manuals
Audi A6 Typ 4G (2011–2018) Owner's Manual / Safety / Child safety / Deactivating the convertible locking retractor

Audi A6 Typ 4G: Deactivating the convertible locking retractor

The convertible locking retractor for child restraints will be deactivated automatically when the belt is wound all the way back into the retractor.

  • Press the red button on the safety belt buckle.

    The belt tongue will pop out of the buckle.

  • Guide the safety belt all the way back into its stowed position.

Always let the safety belt retract completely into its stowed position. The safety belt can now be used as an ordinary safety belt without the convertible locking retractor for child restraints.

If the convertible locking retractor should be activated inadvertently, the safety belt must be unfastened and guided completely back into its stowed position to deactivate this feature. If the convertible locking retractor is not deactivated, the safety belt will gradually become tighter and uncomfortable to wear.

WARNING

Improperly installed child safety seats increase the risk of serious personal injury and death in a collision.

  • Never unfasten the safety belt to deactivate the convertible locking retractor for child restraints while the vehicle is moving. You would not be restrained and could be seriously injured in an accident.
  • Always read and heed all WARNINGS whenever using a child restrained in a vehicle is being used. Special precautions apply when installing a child safety seat on the front passenger seat.

    READ NEXT:

     LATCH system (lower anchorages and tethers for children)

    Child Restraint System anchors and how are they related to child safety To provide a simpler and more practicable way to attach the child restraint on the vehicle seat, Federal regulations require spe

     Installing a child restraint with LATCH lower anchorages

    Whenever you install a child restraint always follow the child restraint manufacturer's instructions. Fig. 171 Lower anchorages: proper mounting Mounting Make sure the seatback of the rear seat ben

     Tether anchors and tether straps

    Fig. 172 Tether anchors: recess flaps behind the rear seat backs The tether anchors for the rear seating positions are located in recesses in the rear window shelf fig. 172. A tether is a straight o

    SEE MORE:

     Balancing

    General Information Before beginning balancing, the following requirements must be fulfilled. Tire inflation pressure must be OK. The tire tread must not be worn down on one side and should be at least 4 mm deep. The tire must not have any flat spots. It is not possible to balance a flat spot

     Underbody Panels, Removing and Installing

    Front Vehicle Underbody Cover, Removing and Installing Removing - Remove the nut -3- and expanding clip -1-. - Remove the front cover -2- forward. - Remove the front cover. Installing Install in reverse order of removal. Center Vehicle Underbody Cover, Removing and Installing Remov

    © 2011-2025 Copyright www.aa6.tochrfr.com