Audi A6 Typ 4G: Unlocking/locking by remote control
Fig. 18 Remote control key: button programming
If the vehicle is unlocked and none of the doors,
the rear lid or hood are opened within 60 seconds,
the vehicle locks again automatically. This
feature prevents the vehicle from being accidentally
left unlocked over a long period of time.
The settings in the Infotainment system determine
if the entire vehicle or only the driver's door
is unlocked when unlocking the vehicle.
WARNING
Read and heed all WARNINGS
.
Tips
- Only use the remote control key when you
are within view of the vehicle.
- The vehicle can only be locked when the selector
lever is in the P position.
- Do not use the remote control when you are
inside the vehicle. Otherwise, you could unintentionally
lock the vehicle. If you then
tried to start the engine or open a door, the
alarm would be triggered. If this happens,
press the unlock button.
- Only use the panic function in an emergency.
READ NEXT:
Applies to: vehicles with convenience key
The doors and luggage compartment lid con be
unlocked/locked without using the remote control
key.
Fig. 19 Door handle: locking the vehicle
Unlocking the veh
Fig. 20 Driver's door: central locking switch
Fig. 21 Rear door: central locking switch
To lock the vehicle, press the
button
.
To unlock the vehicle, press the
button.
When locking the veh
Each door must be locked separately if the power
locking system fails.
Fig. 22 Driver's door: door lock cylinder
Fig. 23 Door: emergency locking
If the central locking system malfunctions, you
must
SEE MORE:
Rear Lid, Adjusting, Gap Dimensions
Special tools and workshop equipment
required
Gauge - Gap Adjustment -3371-
Gap Dimensions on the Sedan
The gap dimensions can be checked with the Adjustment Gauge -3371-.
Dimension -A- = 3.5 mm
Dimension -B- = 5.5 mm
Dimension -C- = 2.2 mm
Dimension -D
Removing
- Remove the front door trim panel. Refer to
→ Body Interior; Rep. Gr.70; Front Door Trim Panels; Front Door
Trim Panel, Removing and Installing.
- Disconnect the connector -1-.
- Open the clip -2- and remove
the trim -3- with the switch from
the door trim