Audi A6 Owners & Service Manuals
Audi A6 Typ 4G (2011–2018) Workshop Manual / Electrical System / Electrical Equipment / Exterior Lights, Switches / Tail Lamp, Removing and Installing

Audi A6 Typ 4G: Tail Lamp, Removing and Installing

Tail Lamp, Removing and Installing, Sedan

- Turn the light switch to position "0".

- Remove the cover -2- from the tail lamp assembly in direction of -arrow A-.

- Remove the bolts -3- and -4-.

- Swivel the tail lamp assembly -1- toward the outside in direction of -arrow B- and loosen the bolt from the clip nut.

- Disconnect the connector.

A94-11127

Installing

Install in reverse order of removal. Note the following:

- Position the tail lamp -4- assembly on the body and push the bolt into the clip nut.

- Insert the centering pins -2 and 3- and tabs on the cover -1- into the mount and into the tail lamp assembly -arrows-.

- Push the cover onto the tail lamp assembly.

  • The tabs must audibly engage in the tail lamp assembly.

A94-11121

Tail Lamp, Removing and Installing, Avant

Removing

- Turn the light switch to position "0".

- Remove the cover -2- from the tail lamp assembly in direction of -arrow A-.

- Remove the bolts -3- and -4-.

- Swivel the tail lamp assembly -1- toward the outside in direction of -arrow B- and loosen the bolt from the clip nut.

- Disconnect the connector.

A94-11257

Installing

Install in reverse order of removal. Note the following:

- Position the tail lamp -1- on the body and push the bolt into the clip nut.

- Insert the centering pins -3 and 4- and tabs on the cover -2- into the mount and into the tail lamp assembly -arrows-.

- Push the cover onto the tail lamp assembly.

  • The tabs must audibly engage in the tail lamp assembly.

A94-11232

    READ NEXT:

     Rear Lid Tail Lamp, Removing and Installing

    Rear Lid Tail Lamp, Removing and Installing, Sedan Special tools and workshop equipment required Trim Removal Wedge -3409- Removing - Turn the light switch to position "0". - Remove the

     Bulb Holder, Removing and Installing

    Bulb Socket, Removing and Installing, Tail Lamp, Sedan Removing - Remove the outer tail lamp. Refer to → Chapter "Tail Lamp, Removing and Installing, Sedan". - Push the locking brack

     Tail Lamp, Correcting Installed Position

    Body Tail Lamp, Aligning, Sedan Adjustment in Direction of Travel: - Turn the light switch to position "0". - Remove the cover -2- from the tail lamp assembly in direction of -arrow A-. -&

    SEE MORE:

     In curves

    Applies to: vehicles with Audi adaptive cruise control Fig. 91 Example: driving into a curve When driving into a curve fig. 91 and out of a curve, the adaptive cruise control may react to an object in the neighboring lane and apply the brakes. You can prevent that by pressing the accelerator pedal

     Final Drive

    Overview - Final Drive 1 - Flywheel Removing and installing. Refer to → Chapter "Flywheel, Removing and Installing". 2 - Shaft Seal For the left flange shaft Between the final drive and the transmission housing Replacing. Refer to → Chapter "Left Seal, Rep

    © 2011-2025 Copyright www.aa6.tochrfr.com