Audi A6 Typ 4G: Rear Doors
READ NEXT:
1 - Front Door
2 - Bolt
8 Nm
3 - Seal
For the door arrester
4 - Bolt
33 Nm
5 - Cap
For the door arrester
6 - Door Arrester
R
Removing
- Disconnect the connector on the A-pillar. Refer to
→ Electrical Equipment; Rep. Gr.97; Connectors.
- Remove the door arrester bolt -2-.
- Remove the cover ca
Removing
- Move the door window into the "closed" position.
- Remove the door trim panel. Refer to
→ Body Interior; Rep. Gr.70; Rear Door Trim Panels; Rear Door
Trim Panel
SEE MORE:
WARNING
The following information applies only to the Audi
A6 model, type 4G, sedan and Avant (not for the A6
allroad). Not for Audi A7 Type 4G.
19" or larger wheels may only be installed if they
are listed in the vehicle documentation.
If installing 19" or larger wheels, an additiona
Flange Shaft Ring, Replacing, 0BC
The ring can only be replaced with the final drive and the
flange shaft removed.
Special tools and workshop equipment
required
Press Plate -VW401-
Press Plate -VW402-
Press Piece - Multiple Use -VW412-
Press Piece - Lower Ball Joint - 3146-
-3-Separating
